Quick Start Guide

2. Secure the post-2 (with Hall switch) to the bottom frame.
￮ Screw: M5 30 screws, 2 screws
Ensure that the limit bumps of the profile connections are located in the grooves
on both sides of the column.
3. Secure column-3 (with cover transfer module) to the bottom frame.
￮ Screw: M5 30 screws, 2 screws
Ensure that the limit bumps of the profile connections are located in the grooves
on both sides of the column.
4. Attach the post-4 to the bottom frame to complete the assembly of the support frame.
￮ Screw: M5 30 screws, 2 screws
Ensure that the limit bumps of the profile connections are located in the grooves
on both sides of the column.
5. Check all the details below to ensure that all beams and posts are installed in the correct position.
Make sure that the two screw holes in the middle of the short beam (rear) face
up.
Ensure that the limit bumps of the profile connections are located in the grooves
on both sides of the posts and beams.
③
mounting side panel and outer cover top
Encouraging words: so great! You've assembled the basic frame of the outer cover, with the midpoint line
right ahead!
1. Insert the two side panels into the frame.
Ensure that the left, right, and lower edges of the side panels are stuck into the
grooves of the corresponding profiles.
2. Secure the guide pipe holder to the top of the outer cover.
￮ Screw: M3 20 screws, 2 screws
3. Secure the outer cover top to the support frame.
￮ Screw: M5 30 screws, 8 screws
Ensure that the upper edges of the side panels are stuck into the grooves of the
corresponding beam.