Quick Start Guide

It is recommended that all screws be pre-locked and then locked together.
4. Connect the LED light strip and the Hall switch to the hood transfer module.
④ assembled the hood doors
Encouragement words: 50% of the achievements have been achieved! Take a break and start the second half
of the game.
1. Secure the door handle to the outer cover door panel.
￮ Screws: M4 12 screws, 2 screws
2. Secure the cover door to the outer cover.
￮ Screw: M4 12 screws, 4 screws
3. Cut out ten sealing grooves of appropriate length, and press into the outer gap of the roof plate, back
plate, side plate and adjacent profiles respectively.
The groove makes the inlay between the acrylic plate and the profile more
stable.
Ensure that the slot bar is installed in the correct way.
⑤ combination cover with machine
Encouragement language: there are less than half of the steps left, come on!
1. Card the bottom holder (bottom) into the corresponding grooves on both sides of the machine plate.
2. Lift the outer cover over the machine and cover the machine down.
Move the cover carefully and slowly to avoid a collision with the machine. At
least two people are advised to work together.
3. Insert the cover wire into the cover transfer module.
Ensure that the wiring port is facing correctly.
4. Use wire cloth to facilitate subsequent steps.
5. Card the execution head connector, hot bed connector, cover connector, and five straight modules into
the corresponding wire holes of the solid line card seat, and then secure the open wire press to the short beam
(rear).
￮ Screw: M5 30,2 out