Quick Start Guide

Do not scatter the wire on the ground to avoid damaging the wiring port.
Whether or not the first feature you experience after completing the assembly is
3D printing, snap the hot bed cable into the solid wire board early at this step.
The wire hole on the far right of the wire press is reserved for the extension line
of the rotating module.
The
⑥
installed the backplane and the exhaust system
Encouragement: You have completed three-quarters of the assembly steps, the end is in sight!
1. Secure the exhaust fan and air duct adapter to the backplane.
￮ Screw: M4 35,4; M4 butterfly nut, 4
2. Connect the exhaust fan to the cover transfer module and cut the appropriate length of the receiving slot
to store the exhaust fan line into the column slot.
3. Secure the backplane to the cover.
￮ Screw: M5 16 low cylindrical head screws, 10 screws
Do not overlock the screws to damage the acrylic plate.
You can install the top two screws, attach the back plate to it, and then install
the other screws.
It is recommended to pre-lock the diagonal screws first, then pre-lock the
remaining screws, and finally lock all the screws in the order of the prelock.
4. Cover the duct into the duct clamp and secure it to the duct adapter.
⑦
plug in, fix, finish
Encouragement language: only a little bit left, persistence is victory!
1. Insert the execution head, cover, hot bed, and five straight modules into the integrated controller.
Ensure that the wiring port is facing correctly.
Make sure that you place the integrated controller in an easy to touch position
so that you can press the emergency stop switch on the top of the controller to
respond to emergencies quickly in time.
To facilitate the touch screen when the cover door is open, it is recommended to
place the integrated controller on the right side of the cover.