Quick Start Guide

8. Pull off the joint wedge at the inlet of the double-nozzle module, then insert the guide pipe into the inlet,
and finally put the wedge back in place.
To remove the guide pipe from the module, remove the joint wedge, and then
press the round clip at the inlet before operating.
9. Secure the rack to the cover.
Insert both ends of the AC power cord into the integrated controller and the power outlet, respectively.
Make sure the power switch is turned off before wiring!
When the machine is energized, do not plug or pull out any connecting lines
without special instructions!
You've already assembled the 3D printer. It's great!
Uncover the stickers on the backboard and start creating good things with Snapmaker right now!
4.2 Preparations
4.2.1, Initialize the settings
1. Turn on the power switch on the back of the integrated controller and start the machine.
To restart the machine, wait at least five seconds without power before starting
again.
2. Initialize the settings. Follow the instructions on the touch screen to complete the following initialization