Quick Start Guide

In case of emergency during 3D printing, press the emergency stop switch on
the top of the integrated controller and stop the operation immediately. After the
risk is lifted, the emergency stop switch is released by rotating it clockwise.
Ensure that the front cover of the dual nozzle module is closed during printing.
You can also send the files to the machine in the workspace, or transfer the files
to the machine through the U disk. For more information, please refer to our
online user manual: In the navigation bar of Snapmaker, official website, click
Support> Product Support> Snapmaker Artisan> User manual.
After printing starts, please pay close attention to the printing situation of the first layer of the model, so as to
find problems in time and avoid waste of consumables. If you need to adjust the parameters during the printing
process, click the setting icon to enter the printing manager. You can both modify the printing parameters such
as the Z-axis offset, working speed, and flow rate, as well as adjust the function settings of the extended
components such as outer covers, and air purifiers.
In case of poor first layer adhesion, you can try the following solutions:

Method 1: Adjust the Z-axis offset in real time during the printing period, and
appropriately reduce the distance between the nozzle and the printing
platform. However, it should be noted that if the nozzle is too close to the
printing platform, the nozzle may not be discharged smoothly, or if the