Quick Start Guide

5 Laser engraving and cutting
5.1 Assemble the laser engraving and cutting machine
1. Move the cam handle of the support platform to the left to be unfastened, and then card the laser
engraving and cutting platform into the support platform.
2. Turn the cam handle supporting the platform to the right to tighten.
Make sure the block is fully inserted into the snap clip.
3. Move the cam handle of the execution head quick switch to the left to the unfastened state, and then
slide the 10W laser module from right to left into the slide seat.
4. Turn the cam handle of the head change slide to the right.
Ensure sure the execution head is fully slid into the slide seat.
5. Insert the execution head cable into the 10W laser module.
Ensure that the wiring port is facing correctly.
6. Insert both ends of the AC power cord into the integrated controller and the power outlet, respectively.
Make sure the power switch is turned off before wiring!
When the machine is energized, do not plug or pull out any connecting lines
without special instructions!
You have already assembled the laser engraving and cutting machine, great!
Uncover the stickers and start creating great things with Snapmaker right now!