Quick Start Guide
Table Of Contents
- 1 Before the start
- 2 Machine assembly
- 3 Cover assembly and use
- 4 The 3D printing
- 5 Laser engraving and cutting
- 6 CNC carving and cutting
- 7 Maintenance and maintenance
5.2 Preparations
5.2.1, Initialize the settings
1. Turn on the power switch on the back of the integrated controller and start the machine.
To restart the machine, wait at least five seconds without power before starting
again.
1. Initialize the settings. Follow the instructions on the touch screen to complete the following initialization
settings: Read the Terms of Use> Select Language> Naming Machine> Connect to Wi-Fi.
The initialization settings is only present on the first boot. To change the above
settings, click Settings on the touchscreen home interface, and then click Wi-Fi,
language, or about the machine as necessary.
5.2.2 Calibrate the laser function
Turn the laser for the first time, and the touch screen guides you to the necessary calibration to ensure the
laser works correctly when it is on. The calibration guide for the laser function consists of two processes:
material thickness measurement calibration and camera calibration. It is recommended to read the introduction
of this section before following the touch screen prompts.