Quick Start Guide

hold each pressure block with two screws, respectively.
Make sure that the fixing tool does not collide with any part of the machine.
For easy operation, you can first remove the laser engraving and cutting
platform from the machine, fix the material on the platform, and then install the
platform back to the machine.
You can also press the four corners of the lime board with four presses, and then
tighten the screws to secure the material. When fixed, do not block the carving
and cutting areas of the material surface. This method is only applicable for
materials with less than 8mm thickness. In addition, you can also use other tools
such as adhesive tape to fix it.