Quick Start Guide

For more information about generating G code, please refer to our online User
manual: In the navigation bar of Snapmaker, official website, click Support>
Product Support> Snapmaker Artisan> User Manual.
5.3.3 Start the first operation
1. Click Export in the bottom right of the Luban page> Load G code into the workspace.
2. In the preview window, click Start Jobs> Online Jobs. Then, in the Select Mode window, select Auto
Measure Thickness> Start.
Before clicking Start, make sure the hood is properly installed, connected, and
the door is closed.
In case of emergency during the laser operation, press the emergency stop
switch on the top of the integrated controller and stop the operation immediately.
After the risk is lifted, the emergency stop switch is released by rotating it
clockwise.
If you use other materials in subsequent laser operations, the thickness
measurements may fail in the following conditions:
• The thickness of the material exceeds 50mm
• The material is transparent, bright, or mirror