Quick Start Guide

Power continued
Artisan's laser carving and cutting function support power outage, even if accidentally stop, can also be a
key recovery!
If a power failure occurs during the operation, you can select resume or cancel the job on the touch screen
after the machine is energpowered.
Replace the module
To replace the module, remove, or add an extension component, you can click the tool button in the upper
right corner of the touch screen home interface> to replace the module, and follow the instructions of the touch
screen without turning off the power switch.
You can also find the process entry through the following path: Set up> Module
Assistant> Module replacement.
You can also turn off the power switch of the machine before replacing the
module, remove, or add an extended component.
Firmware update
You can upgrade the firmware via the Wi-Fi or U disk. When a new firmware exists, the touch screen
displays an update prompt after the connection. We recommend timely upgrading the firmware to the latest
version.
By using the Wi-Fi:
1. Connect the machine to the Wi-Fi;