Quick Start Guide
Table Of Contents
- 1 Before the start
- 2 Machine assembly
- 3 Cover assembly and use
- 4 The 3D printing
- 5 Laser engraving and cutting
- 6 CNC carving and cutting
- 7 Maintenance and maintenance
3. Click Export> Load the G code into the workspace, and then in the G code file panel click Send to the
Machine, via Wi-Fi sends the G code for the test file to the machine.
You can also send the G code files to the machine via the U disk, or work online
via the Luban.close
For detailed steps, refer to our online user manual: Midpoint in the navigation bar
of the Snapmaker website
Click Support> Product Support> Artisan> User Manual.
6.3.3 Set the working origin and start the carving
Function introduction: Working origin
Determine the carving area by setting the working origin. The working origin corresponds to the coordinate
origin in the software (0,0).
You can also set the working origin with the L-shaped positioning block. For
detailed steps, please refer to our online user manual: In the navigation bar of
Snapmaker, the official website, click Support> Product Support> Artisan> User
manual.