Quick Start Guide

4. Click Z + to lift the CNC tool until it is higher than the clamp, and then click the running frame to check
whether the working origin is incorrect. If the running border area is not the carved target area, or when the
CNC tool collides with any part of the machine, reset the working origin and run the border.
If you have run the running frame at the CNC tool above the clamp, you can
drop the CNC tool as necessary
Run the border again.
If the CNC tool collides with any part of the machine, press the emergency stop
switch on the top of the controller, at risk
After lifting, rotate the emergency stop switch clockwise to release it. If the CNC
tool is damaged, replace the tool.
1. Click to start work and the machine will start carving.
Make sure that the controller is placed at easy contact points. In case of
emergency during the operation, press the emergency stop switch on the top of
the controller and stop the operation immediately. When the risk is lifted, rotate
the emergency stop switch clockwise to release it.
It is not recommended to open the outer cover exhaust fan during the operation,
otherwise the dust generated by the carving will be attached to the inner surface