Quick Start Guide
Table Of Contents
- 1 Before the start
- 2 Machine assembly
- 3 Cover assembly and use
- 4 The 3D printing
- 5 Laser engraving and cutting
- 6 CNC carving and cutting
- 7 Maintenance and maintenance
By using the Wi-Fi:
1. Connect the machine to the Wi-Fi;
2. Click Settings> Firmware Upgrade on the touch screen;
3. If a new firmware appears, click to download now;
4. When the firmware download is complete, click Update now.
Through the U disk drive:
5. In Snapmaker, in the navigation bar of the official website, click on Support> Product Support>
Snapmaker Artisan> firmware, download the latest firmware, and save it to the U disk;
6. Insert the U disk into the controller;
7. On the touch screen, click Settings> Firmware Upgrade> Local Update;
8. Select the firmware package file, and then click on Update.
Replace the module
To replace the module, remove, or add an extension component, you can click the tool button in the upper
right corner of the touch screen home interface> To replace the module, and follow the instructions of the
touch screen without turning off the power switch.
You can also find the process entry through the following path: Set up> Module
Assistant> Module replacement.
You can also power off the machine, replace the module, remove, or add
extended components.