Quick Start Guide

4. Scrscraping to the nozzle surface without residue, the cleaning is completed.
7.2 Laser engraving and cutting
7.2.1 Clean the laser lens shield
Maintain the scene
10W laser module after a period of time, laser lens protection goggles may accumulate excessive dust or oil,
resulting in a significant reduction in laser cutting capacity. At this point, the laser lens shield is cleaned to
restore the engraving and cutting capability of the laser module.
Maintenance frequency
At least once a week.
Maintenance method
1. Prepare cleaning tools: cotton swabs, high purity alcohol (bring your own).
Please use alcohol with no less than 75% purity. Among them, alcohol with a
purity higher than 99% had the best wiping effect.
2. Power off and remove the 10W laser module from the machine.
3. Dip a cotton swab with alcohol in it and put it into the air hood. Wipe the laser lens shield from the inside
out, starting from the center of the lens.