Ultra Rail Installation Manual

snapnrack.com
18
Flat Tile Hook
INSTALLATION INSTRUCTIONS
1) Using roof attachment locations
drawn during system layout, remove
roof tile where the roof attachment
will be installed and drill two pilot
holes through the roofing material
into the roof framing member.
2) Apply roofing sealant and
attach the Tile Hook with (2) 5/16”
lag screws, drive lag screws for
minimum 2.5” embedment into the
roof framing member.
3) If deck level flashing is
required, integrate roof felt or a
flexible flashing with the existing
underlayment and over the Tile
Hook.
4) Replace the roof tiles.