Ultra Rail Installation Manual

snapnrack.com
27
Module Installation
INSTALLATION INSTRUCTIONS
1) Snap the channel nut into the top
channel of the rail.
2) Slide the clamp flush to the
module with the top lip of the end
clamp over the top edge of the
module frame.
3) Tighten hardware.
4) Install end cap to finish.
SnapNrack Adjustable End Clamp
Take care to avoid having wires
pinched between modules and rails, as
this can lead to system failure and be
dangerous.
Install Note:
Adjustable End Clamps require extra
rail to ensure that channel nut is fully
engaged.
Install Note: