Ultra Rail Installation Manual

snapnrack.com
28
Module Installation
INSTALLATION INSTRUCTIONS
1) Slide the preassembled Universal
End Clamp (UEC) into the end of
the rail.
2) Lift the module and slide the
clamp far enough under the
module to pass the lip of the
bottom edge of the module frame.
3) Use the pull tab to hold the UEC
taut towards the end of the rail and
tighten hardware.
4) Install end cap to finish.
SnapNrack Universal End Clamp
Rail can be cut flush to the module
when using UEC.
Install Note:
Modules need to be grounded
separately when Universal End
Clamps are the only type of clamp
attaching a module.
Install Note:
Take care to avoid having wires
pinched between modules and rails,
as this can lead to system failure and
be dangerous.
Install Note: