Ultra Rail Installation Manual

snapnrack.com
36
INSTALLATION INSTRUCTIONS - MLPE RAIL ATTACHMENT
1) Snap the SnapNrack MLPE Rail
Attachment Kit channel nut into the
desired location on the rail where
the microinverter will be installed.
2) Install the microinverter
mounting plate onto the bolt of the
MLPE Rail Attachment Kit, ensuring
that the large fender washer is
between the rail and mounting
plate.
3) Tighten hardware.
Bolt and washers may need to be
removed and then replaced.
Install Note:
MLPE Installation
INSTALLATION INSTRUCTIONS - MLPE FRAME ATTACHMENT
A
1) Slide the backplate channel of
the MLPE device under the MLPE
Frame Attachment Kit bolt. The
MLPE mounting plate should rest
against the MLPE mounting plate
backstop on the MLPE Frame
Attachment Kit.
2) Position the MLPE Frame
Attachment Kit on the module
frame flange in a location that
will not interfere with mounting
system components. The module
frame flange should rest against
the module flange backstop on the
MLPE Frame Attachment Kit.
A
3) Tighten the mounting bolt on the
MLPE Frame Attachment Kit.
The MLPE Frame Attachment Kit
bonds the following components:
Module Frame, MLPE backplate and
Smart Clip.
Install Note:
MLPE Attachment Kits are approved
for bolt lengths between 1” and 1-1/2”
long.
Install Note:
Avoid blocking module frame
drainage holes when installing the
MLPE Frame Attachment Kit.
Install Note:
4) Connect the module leads to the input
con-nectors on the MLPE device and manage
con-ductors with the integrated Smart Clip.