Manual

7. Allowdetergentto soakinbetween3-5minutes
beforewashingandrinsing.ReappJyasneededto
preventsurfacefromdrying.DoNotallowdetergent
to dryon(preventsstreaking).
IMPORTANT:Youmustflushthechemicalinjection
systemaftereachusebyplacingthefilterintoabucketof
cleanwater,thenrunthepressurewasherinlowpressure
for 1=2minutes.
Pressure Washer Rinsing
For Rinsing:
I. Apply safety latch to spray gun.
2. Remove black chemical nozzle from nozzle extension.
3. Select and install desired high pressure nozzle following
instructions "How to Use Spray Tips".
4. Keep spray gun a safe distance from the area you plan
to spray.
WARNING
. Keep spray nozzle between 8 to 24 inches away from cleaning
surface.
. Operate this unit on a stable surface.
. Be extremely careful ifyou must use the pressure washer from
a ladder, scaffolding or any other relatively unstable location.
. Firmly grasp spray gun with both handswhen using high
pressure spray to avoid injury if gun kicks back.
5. Apply a high pressure spray to a small area and then
check the surface for damage. If no damage is found,
you can assume it is okay to continue rinsing.
6. Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
I. Place chemical injection siphon/filter in a bucket full of
clean water.
.
3.
4.
Attach black low pressure spray tip.
Flush for 1-2 minutes.
Shut off engine.
iMPORTANT: Simply shutting OFF engine will not
release pressure in the system. When the engine has
shut down, squeeze the trigger on the spray gun to
relieve the pressure in the hose.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°EThe system engages to cool the pump by
discharging the warm water onto the ground.