INSTALLATION INSTRUCTIONS REAR LIFT KIT MFG. NO. 1690404 NOTE NOTE This kit cannot be used on tractor equipped with a An electric lift is recommended for 38 rotary tiller. Nickers hydro static pump. The kit may be used with either the manual lift or power lift kit. ZgrxerzpmmpoRy . Hex Lockout, FRONT . Cotter Pin, 3/32x 3/4 ‘ . Lift Cable Says. . Hex Cap screw, x -1/ () Cable Guard Spacer . Lock washer, 1/4 .
3. With the right end of the lift lever saith flush with the edge of the right bar assembly, tighten the right collar setscrew so that there is no side play in the shaft (figure 2). 4. Install the left collar so that the lip (small 0.d.) fits flush inside the hole in the left upright bar assembly. Tighten the setscrew (figure 2). 5. To per-set the length of your cable assembly, assemble the lift cable, hex jam nut, and lift clevis to a length of from center of hole in clevis to center of cable eye.
10. On hydro static drive units, install the belt stop to the inside rear of the left side plate by removing the nut and lock washer from the rear cap screw holding on the hydro static control spring support (figure 5). Place the stop on the cap screw so that the leg of the stop is over the top of the cable. Replace the lock washer and nut, making sure that there is at East 1/8 inch clearance between the side of the belt stop and the adjusting nut on the hydro static control shaft to avoid interference.