Use and Care Manual

OPERATION

STARTING AND STOPPING THE CHAIN SAW

A. To start the chain saw:

• Make sure chain tension is at desired setting. Refer to adjusting the chain tension in the Care

and Maintenance section of this manual.

• Make sure the chain cover lock knob is tight to the chain cover.

• Make sure no objects or obstructions are in the immediate vicinity which could come in contact

with the bar and chain.

• Fit the battery into the chain saw.

• Press the power button on the left of the rear handle. You will hear two beeps signalling the

chain saw is active.

• Press in the safety lock. This makes the trigger switch operational.

• Press and hold the trigger switch and keep it pressed for continued operation.

B. To stop the chain saw:

• Release the switch trigger to stop the chain saw.

• Upon release of the trigger switch, the safety lock will be automatically reset to the lock

position.

NOTE: It is normal for the chain to coast to a stop once the trigger switch is released.

On/Off Button

Switch Trigger

Safety Lock Buttom

Not for Reproduction