Operator’s Manual Congratulations: You have just purchased one of the most versatile machines on the market. With reasonable care and service it should give long and satisfactory service. Any mechanical device con be potentially dangerous if not used properly. No accident prevention program con be successful without the wholehearted cooperation of the person who is directly responsible for the aeration of the equipment.
1. 2. ASSEMBLY, OPERATION AND SERVICE INSTRUCTIONS FOR SNAPPER TILLER MODELS 300 AND 500 ASSEMBLY A. install fines on tiller using 1-1713 pins and 1-1714 hair pins. 8. Inst alt left and right hand handle assembly using two x 3-3/4 hex head cap screws and two lock nuts. {Note: Do not tighten nuts until all items are in place on handle. C. Install cross brace using four 1/4/ x 28 x 1-1/2 curved head bolts, four hex nuts and four internal tooth lock washers. D.
4. LUBRICATION A. Engine Service and lubricate engine per instructions in Engine Manual, B. Transmission Transmission is Lubricated by removing plastic plug and 9-0485 check plug on right hand side of ease. Fill transmission with Snapper “00" Grease, Part No. 1-1050, until grease level reaches check plug hole. Replace plastic plug and check plug. NOTE: Do not overfill. Check grease level with machine in level position. Check every 10 hours of operation, 5.
TIPS ON CHOOSING THE RIGHT TINES EACH SET OF TINES ARE FULLY INTERCHANGEABLE. TO CHANGE TINES, REMOVE 1-1714 HAIR PINS AND 1.1713 PINS. TAKE ONE SET OFF, PUT OTHER SET ON AND REPLACE THE PINS. Hem Pant No. Description 1 5.0329 Complete Set ta 5-0338 R. H. Quayside Ass'y. ib 5.0336 R, H. Inside Ass'y. lc 5-0335 L. H. Inside Ass’y. Td 5-0337 L H Quayside Ass’y. THE SLASHER TINE WAS DESIGNED TO MINIMIZE THE WRAPPING OF WEEDS. IT HAS A TILING WIDTH OF 26 INCHES.
Stem Part Na. Description 1 50328 Complete Set Ta 5-0334 R.H. Outside Ass'y. 1b 5-0332 R. H. Inside Ass'y. Tc 50331 L. H. Inside Ass'y. 1d 5-0333 L. H. Outside Assyria. THE TINE BLADES ARE MADE FROM HEAT TREATED FORGED STEEL AND ARE SELF SHARPENING. IT HAS A TILLING WIDTH OF 26 INCHES. THESE TINES ARE RECOMMENDED FOR NORMAL CULTIVATION AND MULCHING JOBS. PICK TINES Hem Part No. Description Qty. 1 5-0330 Complete Set 1 la 5-7073 R. H. Ass’y. 1 b 5.7072 L H. Ass'y.
