Manual

STEP9: Installbeltguardbetweenpulleyguard
andbeltguardsupportcliponfrontpartof blower
mount.Securewith two 5/16nylonwing nuts.
Tightennutssecurely.
WING NUTS
WEIGHT KIT INSTALLATION
!! Warning: Weight kit must be installed prior to
installing clamshell kit. Failure to do so may
result in Iongitudal tipping of unit.
STEP 10: Lay weight mount channel, with installed
weights, across front end of machine as shown.
Secure to machine with two clamp plates, one
under each caster arm, each held on with two 3/8-
16 x 4" hex bolts and lock nuts. See Inset. Tighten
securely.
WEIGHT
MOUNT
CHANNEL
CLAMSHELL KIT INSTALLATION
STEP 11: Install bumper mount standoffs onto rear
bumper of machine, utilizing existing hardware on
machine. NOTE: Invert hardware when installing
standoffs, installing bolts out through bumper with
nuts facing out.
NOTE: When installing standoffs, be sure that the
bumper mount plate mounting holes along the
back bar of both standoffs are oriented towards the
right side of the machine. Refer to the Parts List
section of the manual.
STEP 12: Install bumper mount plate onto stand-
offs with four 5/16-18 x 3/4 hex bolts, securing with
four 5/16-18 hex flange lock nuts. Tighten secure-
ly.
7