Manual

Preparation
,w
0,3
=,.,.
WARNING:Beforedoingany assemblyor
maintenancetothe mower,removethe wire
from the sparkplug.
NOTE.In this instruction book, left and right describe the
location of a part with the operator standing behind the
handle.
Unpacking
The mower was fully assembledat the factory. When the
mower was put in the carton, the handlewas put in the
storage position. To put the handle in the operating position,
follow the steps below.
Handle
1. Remove the mower from the carton.
2. Remove all packing material from the mower and the
handle.
3. Turn the knobs (A, Figure 1) on either side of the lower
handle (B) to retract the locking pins. Raisethe lower
handle, aligning it with one of the three sets of holes in
the handle brackets (C). Turn the knobs to releasethe
locking pins and securethe lower handle.
4. Put the upper handle(A, Figure 2) in the operating
(upright) position. Tighten the wingnuts (B).
NOTE. Theheight of the handle can be set for operator
comfort. See "HandleHeight".
CAUTION:Becareful when you fold or raise the handle. Do
not damagethe cables. A cable that is bent will not work
correctly. Beforeyou use the unit, replace a bent or damaged
cable.
,
Hold the engine stop lever againstthe handle. (Refer to
section entitled 'EngineStop Lever'.) Slowly pull the
recoil-start grip (A, Figure3). To attach the recoil-start
grip to the rope guide (B), twist the rope through the
rope guide mounted on the right side of the handle.
Figure 1: Unfolding the lower handle
Figure 2: Unfolding the upper handle
Figure 3: Attaching the recoil-start grip
4 www.snapper.com