Dust Collector Operator's Manual

6. Install the sleeve clamp (C, figure 11) to the connect-
ing sleeve (A) with l/4-20 x l/Z slotted truss head
screw (D) and
nyloc nut (E). Install the connecting
sleeve inside the collar of the cover and position
sleeve clamp (C) over the support tube (B).
‘23!i4
Figure 13
A. Straight Rod
B. Cord Loop
C. Bolt
Figure 11
A. Connecting Sleeve
D. Truss Head Screw,
B. Support Tube
l/4-20 x 112
C. Sleeve Clamp
E. Nyloc Nut
7. Thread the straight rod (A, figure 12) which has an
eyelet on each end through the sleeve at the front of
the cover.
Figure 14
A. Support Tubes B. Locking Tab
. ..-
10. Install the six inch rubber strap (A, figure 15) at, the
back of the box. Hook the strap over the metal loop
(B) on the frame rod, which protrudes through the
cover. Close the hook with a pair of pliers. Hook the
other end of the strap over the door lock (C) on the
bOX.
Figure 12
A.
Straight Rod
8. Pinch the black cord loop (B, figure 13) and thread it
through the eyelet on each end of the rod. Next, pull’
the loop over the top bolt (C) on each side of the
box. The rod gives added support to the cover at the
front of the box.
9. Inside the cover at the front, there is a long tab with
an eyelet on the end. Pull this tab over the top of the
support tube (A, figure 14) and back under the sup
port tube before threading it through the slot in the
cover. This locking tab (B) secures the cover to the
support tube when the cover assembly is locked into
the open position for dumping.
‘;y
Figure 15
A. Metal Loop
B. Rubber Strap
C> Dc+ock
..,~
‘., ,_,
7