Installation Instructions

- 5 -
Non-compatible Outlets
Remember that this ConnectLight is designed to fit over standard
duplex and décor outlets with side screw terminals. These types of
outlets represent the vast majority of outlets in North American homes.
Below are some examples of nonstandard outlets. This ConnectLight
will not work with nonstandard outlets. You will need to pick a different
outlet for your ConnectLight. A list of compatible outlets is available at
www.snappower.com/pages/trouble-compatibility.
Switch
Combination
USB outlet
OFF
Décor
Light Switch
Support
Email: [e-mail]
Duplex w/o
screw terminals
Orientation:
The ConnectLight must be installed with the LEDs on the same side as
the ground of the outlet. If you install the ConnectLight with the LEDs
on the same side as the power slots, the ConnectLight may not work.
Incorrect Orientation
No side
screw
terminals
Non-compatible Outlets
Correct Orientations
Troubleshooting
Need Additional Help?
www.snappower.com/pages/troubleshooting
GFCI
Test and
Reset
Buttons
Ground
LEDs
Power
Slots
Ground
LEDs
LEDs may not illuminate
Ground
LEDs
The next several pages show specific examples of non-compatible
outlets, obstructions resulting from the way your outlet was installed, and
some adjustments you can make. Please be careful when correcting
these problems and always remember to turn the power off before
working around electrical wiring! Test the outlet to be sure you turned off
the correct breaker. If you are not sure about any part of these
instructions, please consult an electrician.