Installation Instructions

- 6 -
Obstruction 4: Wires in the way
In order for the prongs to fit
around the outlet the areas next to
the screw terminals need to be
free from obstructions. If there are
wires blocking the side screw
terminals, they will need to be
moved. If you are unsure of how
to do this, or if you see bare wires
next to the screw terminals,
please consult an electrician.
Obstructions
The way your outlet was initially installed could create a number of
obstructions that prevent the ConnectLight from being installed and/or
operating correctly. Be sure to turn off electrical power before working
around outlets. If you are unsure about any of these instructions,
please consult an electrician.
Obstruction 2: Screws may be all
the way out and catch the ends
of the prongs. To solve this,
simply maneuver the prongs
around the screws during
installation.
Obstruction 1: Sheet rock or other
wall coverings can prevent the
prongs from passing around the
outlet. This can be solved by
removing the excess sheet rock
near the screw terminals. If you are
unsure of how to properly do this,
please consult an electrician.
Obstruction 3: Outlet not centered
If your outlet is not centered,
there might not be room to insert
the prongs on one side. If this is
the case, your outlet will need to
be centered. If you are unsure of
how to do this, please consult an
electrician.
Troubleshooting
Sheet
Rock
Sheet
Rock
Extended
Screws
Extended
Screws
These wires
may prevent
the Product
prong from
contacting the
screw
terminal
These wires
may prevent
the Product
prong from
contacting the
screw
terminal