Installation Instructions

- 8 -
SnapPower warrants that the ConnectLight accompanied by this
limited warranty is free from manufacturing defects in materials
and workmanship for a period of one (1) year from the original
purchase. For more information about the warranty and
limitations it includes go to: www.snappower.com/pages/warranty
or scan the QR code.
Revision date: 10/15/
2020
This device complies with Part 15 of the FCC Rules and this
device also contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation,Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
SNAPPOWER CONNECTLIGHT LIMITED ONE-YEAR WARRANTY
Warning
Changes or modification to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
RF Exposure Information
This equipment complies with FCC/ISED radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the FCC/ISED
radio frequency exposure limits, human proximity to the antenna shall not be less than 20
cm during normal operation.
Class B digital device or peripheral or cordless phone
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules and . These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of more the following measures:
▪ Relocate the ConnectLights to a different outlet
▪ Increase the separation between ConnectLights
▪ Connect ConnectLights to outlets on different circuit breakers
▪ Consult the dealer or an experienced radio/TV technician for help
Scott Owen, responsible engineer
SnapPower, 426 E 1750 N Unit D, Vineyard UT, 84057
Email: [e-mail]
Phone: [phone]
FCC/IC INFORMATION
Troubleshooting
ConnectLight
01CL-###-SM10
FCC ID: 2AWY2-SM10
IC: 26430-SM10