Instructions / Assembly

ManualsBrandsSnapSafe ManualsGun SafesSuper Titan Large Fire-Resistant 24-Gun Modular Safe with Electronic and Mechanical Lock Black

SNAPSAFE® TITAN ASSEMBLY

1. Unpack and lay out all parts.

2. Thread DOOR HANDLE SPOKES onto the hub on DOOR.

3. Install a fresh high-quality 9v battery in the Entry

Keypad. (See attached instructions)

4. Remove temporary door hinge bolts from door hinges.

5. Enter the factory combination code and open the DOOR,

lift it off the DOOR FRAME (Part #6) and set aside.

6. Lay BACK (Part #5) face down and assemble each part as

labeled and pictured.

7. For additional help you can watch our “Live Action

Assembly Video” on the “Features” page at

www.snapsafe.com

Notes:

1. Each part is marked with an assembly number, orientation

and instructions.

2. Each part’s orientation: TOP, BOTTOM, FRONT, etc. matches

its orientation in the assembled vault. LEFT and RIGHT are as

you face the front of the vault.

3. For easier assembly, remove the FIRESHIELD blankets from

the TOP, BOTTOM and SIDEWALLS, and then stuff them back

into place before interior assembly.

4. Screw on nuts loosely at ﬁrst. Once all Exterior Panels are

aligned and seated, tighten the nuts.

5. The INTERIOR SIDE PANELS are designed to ﬁt snuggly.

Insert them through the door opening bottom-to-top and then

slide into ﬁnal position front-to-back.

6. Insert the INTERIOR BOTTOM PANEL through the door

opening between the front and back shelf strips and then

drop into position front-to-back.

For all Customer Service questions call toll free: 1-877-214-4470

Visit us at www.snapsafe.com

BACK

LEFT SIDE RIGHT

SIDE

TOP

BOTTOM

DOOR FRAME DOOR

BOTTOM INTERIOR

PANEL

TOP INTERIOR PANEL

LEFT

INTERIOR

PANEL

RIGHT

INTERIOR

PANEL

DIVIDER

LOWER

SHELF

LOWER

SHELF

GUN RACK DIVIDER TOP

UPPER SHELF

FULL GUN RACK

SnapSafe

is a Hornady

Company.

Summary of content (3 pages)

PAGE 1
SNAPSAFE® TITAN ASSEMBLY 1. Unpack and lay out all parts. 2. Thread DOOR HANDLE SPOKES onto the hub on DOOR. 3. Install a fresh high-quality 9v battery in the Entry Keypad. (See attached instructions) 4. Remove temporary door hinge bolts from door hinges. 5. Enter the factory combination code and open the DOOR, lift it off the DOOR FRAME (Part #6) and set aside. 6. Lay BACK (Part #5) face down and assemble each part as labeled and pictured. 7.
PAGE 2
BATTERY AND SPOKE HANDLES DOOR FRAME LEFT SIDE TOP RIGHT SIDE BACK BOTTOM TOP INTERIOR PANEL RIGHT INTERIOR PANEL LEFT AND RIGHT SIDE LINERS LEFT INTERIOR PANEL BOTTOM INTERIOR PANEL STAND SAFE UPRIGHT AND HANG DOOR DIVIDER GUN RACK DIVIDER TOP SHELVES For all Customer Service questions call toll free: 1-877-214-4470 Visit us at www.snapsafe.com SnapSafe® is a Hornady ® Company.
PAGE 3
INSTALLING AND REPLACING ENTRY KEYPAD BATTERY Install only a high-quality alkaline battery in the compartment in the back of the Entry Keypad following the steps below. 1. Remove Entry Keypad. Slide it up and carefully pull it away from the vault door. (Fig.1) Note: Do not pull on the Keypad with too much force as to damage the cable. 2. Snap new battery into the connector clip, and slide it into the battery compartment top down so that the wires will not be pinched between the battery and the vault door.