ROTHER Instruction Manual

you can expand on this further by multing the rumble chaos signal into an

envelope follower (The snazzyfx wow and ﬂutter module has a built in envelope

follower.... simply plug in your signal into the wows input then use the "env out

"jack as a new CV source!!

have the envelope follower cv control the cut off of a ﬁlter!#!

crazy patch-AUDIO/CV-DAW/DRUM LOOP ETC!!!

this patch is more of an experimental technique but it should get you in the mode

of #trying anything!

patch a drumbeat or loop from a DAW using silent way (for proper levels) OR

boost a daw signal to euro levels with an interface module.!

now using a mult/stack cable patch that signal into the CV input of the chaos

brother AND into the FM #input of a resonant ﬁlter. use a step sequencer or vclfo

to create a little timed sawtooth wave melody ...you can have the "clock" of the

sequenced melody coming from the gate out of the chaos brother using a stack

cable)!

patch the out of the ﬁlter into a VCA.!

get an ADSR ready. take the gate out of the chaos brother and #plug it into the

ADSR #gate input.!

plug the output of the VCA into the snazzyfx wow and ﬂutter and mix in some

delay with wet / dry.!

now take the Y out of the chaos brother and patch it into the delay CV input jack

of the well and ﬂutter. turn up the depth control to Adjust delay time CV. take the

X output of the chaos brother and patch it into your sawtooth vco expo in. adjust

cv expo depth to taste.!

for more weirdness:!

if you boost the drum beat/loop loud enough #you could mix the X out of the

chaos brother in with the sawtooth audio , using a mixer before the ﬁlter!!!