ROTHER Instruction Manual

SECTION A!
!
!
CONTROLS!
!
1.chaos control !
!
Intensity increases from left to right!
!
all the way left there's no chaotic activity at x/y outputs--it's almost like a sine
wave at far left.!
!
As you turn to the right your signal becomes more and more chaotic.!
!
THINK OF THIS AS THE AMOUNT OF CHAOS IN THE OUTPUT. !
ALL THE WAY LEFT EQUALS NO CHAOS…JUST A SINE LIKE SIGNAL.!
!
FOR BEST RESULTS, CHAOS SETTINGS 80-100% ARE WHERE YOU
WOULD NORMALLY STAY BUT IT'S USEFUL TO TURN FROM LEFT TO
RIGHT DURING LIVE !PASSAGES OR TURN FARTHER TO THE LEFT WHEN
YOU JUST WANT A PERIODIC SIGNAL, ETC."
!
REMEMBER, THE CHAOS KNOB INTERACTS WITH THE SPEED KNOB, BUT
THE CHAOS KNOB IS THE ONLY CONTROL WHICH DETERMINES THE
ONSET OF CHAOS. THE CV INPUT CAN START, STOP, AND INFLUENCE
THE INTENSITY OF THE CHAOS, BUT IF THE CHAOS KNOB IS NOT SET
HIGH ENOUGH, NO AMOUNT OF SPEED OR CV WILL START THE CHAOS.!
!
2. speed control!
!
this control works in tandem with the chaos control"!
all the way left = lowest speed!
all the way right is highest speed!
!
it is important to remember that the speed of the chaos affects your chaotic gate
outputs. !
!
also keep in mind the speed control works in tandem with the CV INPUT and CV
DEPTH CONTROL.!
!