User Manual

!
!
!
!
!
!
!
!
!
!
!
!
TIDAL WAVE CONTROLS!
!
TOP TWO ROWS!
!
1. INITIAL WAVE CONTROL (sets gain and offset of WS (waveshaper/wavefolder)!
!
2. Q CONTROL- sets resonance of the VCF section/ amplitude of Sine OSCILLATOR-
interacts with 21. Q mode switch. set to HI-q and turn q pot up for SINE OSCILLATOR.
HIGH Q values reduce volume in NRML setting. In COMP setting, volume remains more
constant at high q.!
!
3. CUTOFF/PITCH- cutoff control for VCF section. Also sets Pitch when using in SINE
mode with 1/v OCT jack (25. VCF 1/v)!
!
4.LFO SPEED. sets initial speed of (vc) LFO. jack 27 adds pitch offset via CV!
!
5. WS MOD ATTENUVERTER- SETS INTENSITY OF WS MOVEMENT. SET 1. and
9/10/11, then add more or LESS positive or negative CV with the knob (left is neg, right
is pos middle is NONE)!
!
6. Q MOD ATTENUVERTER- sets amount of VCF resonance modulation coming from
Q cv jack or LFO BUS (which connects to WS OR ENV via CV BUS switch. (or off)
When nothing is plugged into the WS CV/BUS jack, WS is normalled to connect to LFO
side of LFO BUS Switch.!
Q and FILT MOD are always sent the opposite side of the CV BUS SWITCH. So if you
set the switch to WS, then the Q mod attenuverter knob will control the amount of ENV
sent to Q depth of the VCF. (which is dependent on the attack and release and auto trig
settings of the envelope section) or vice versa. DONT FORGET TO TURN THE CV
BUS TO OFF when you are trying to set up the TIDAL WAVE as a more traditional
SYNTH VOICE. Why? So the Envelope or LFO are not varying the Pitch (cutoff) and
Amplitude (Q) of your VCF In HI-Q mode (SINE OSCILLATOR) which is feeding into
your Wavefolder!!!