Operation Manual

53
snom 715 User Manual Using the Phone
Rejecting anonymous calls
With this setting you can make your phone reject calls from phones that are blocking or not transmitting
their numbers.
Please note: Calls from analog phone connections without caller ID will, most likely, be
received as anonymous calls. They will be rejected if you turn this function on.
Activating rejection of anonymous calls:
1. Press
Settin
.
2. Press 2 Call Features.
3. Press 3 Incoming Calls.
4. Press 1 to change the setting "1
Reject anonymous" to "1 Reject anonymous".
5. Press
for two seconds to return to the idle screen.
Deactivating rejection of anonymous calls:
1. Press
Settin
.
2. Press 2 Call Features.
3. Press 3 Incoming Calls.
4. Press 1 to change the setting "1
Reject anonymous" to "1 Reject anonymous".
5. Press
for two seconds to return to the idle screen.
Call forwarding
The phone can be set to forward incoming calls, either always or under certain conditions. The settings
can be done on the phone and on the web interface. For further information on using the web interface
for these settings, see "Call forwarding" on page 70.
Forward All: Forwarding all incoming calls to the number of the phone, extension, or mailbox
specified as this function’s target.
As the default setting, the function key
CFwd
in the function key line turns forwarding of all calls
on and off, but you can also map the function onto another function key or use the settings menu as
shown in the table, below.
Forward when Busy: Forwarding calls ringing while phone is busy to the number of the phone,
extension, or mailbox specified as this function’s target.
Forward after Timeout: When a call starts ringing, the phone will wait for the number of seconds
specified in the setting "Call forwarding time". If the call is not accepted by the end of this time period,
it is forwarded to the number of the phone, extension, or mailbox specified as this function’s target.