Quick Installation Guide

21
Registering the handset - Manual registration (triggered via LINK button on base)
1. Make sure the base station is connected to power and the network.
2. Press the MENU/Confirm key.
The User Settings screen appears.
3. Press
or to scroll down to Registration and press OK.
The Registration screen appears.
4. With This device selected, press OK.
The “This device” screen appears.
5. With The base LINK key selected, press OK.
The handet displays:
Press and hold
the LINK key
at base for
4 seconds
Then, press
the # key
at the Handset.
6. Press and hold the LINK button on the base station for four seconds.
The
(power) and (SIP) LEDs flash green.
7. Press the # key on the handset to begin registration.
The handset briefly displays “Press the WPS button on your Hub .
The handset displays “Registering... Please Wait.”
8. If you are promted to enter a PIN, enter the PIN and then press OK.
The default PIN is 0000.
If registration is successful:
The handset beeps and displays “Handset X Registered” .
If registration fails:
The handset displays “Registration failed”. Press OK.
• If the handset displays “Device not registered to base station.”,
press Reg. Place the handset in the charger again for a few seconds,
remove it and try the registration steps again.
• If the handset displays “Out of range. Searching for base...”, move the
handset closer to the base, and try the registration steps again.
• If the handset displays the idle screen, it means the handset was
already registered to another base. To register the handset to a
different base, try the registration steps again.