Operation Manual

20
v1.02
Admin and Installation Guide M700, M300 Configuring
User Interface of the Unit
Status LED
Fig. 6
LED Status Indicator
At the front of the unit there is a multicolored LED for status signaling (Fig. 6). After the PoE cable - or
the PoE injector cable, if PoE is not available - is connected to the unit, the orange LEDs will begin to
blink, indicating that the unit is booting. When the solid green LEDs come on, the unit is connected to
the network and is operational.
LED indicator System state
Solid green Operational
Blinking orange Booting
Blinking red Network or registration failure
O No power
Green, flashing rapidly Software update in progress
Reset Key
The reset key on the back of the unit (see Fig. 1 on page 16) is used to return the settings to factory
defaults. To perform a factory reset, press the key with an object like the end of a paper clip for at
least 10 seconds.
Reset key
Footstand
Holes for
wall mounting
C
: Holes for
ceiling plate
Cable guide
C
C
C
Fig. 7