Operation Manual
Table Of Contents
- Table of Contents
- Copyright, Trademarks, Legal Disclaimers
- Important Information
- Introduction
- Setting Up
- Configuring
- Central Directory
- Firmware Update
- Web Interface Settings
22
v1.02
Admin and Installation Guide M700, M300 Configuring
1. Mark the centers of the two holes on the wall. The centers have to be 98 mm (3.86") apart
horizontally (Fig. 2, above).
Note: When the device is mounted on the wall, the connectors for the Ethernet cable
and the power adapter are on what in this position is the bottom of the device (Fig. 4). It
is therefore advisable to mount the device above the Ethernet jack and the power outlet
in the wall.
Fig. 4
2. Drill the holes and insert the wall anchors flush to the wall.
3. Screw in the screws as shown in Fig. 3.
4. Place the two top holes on the back of the device (Fig. 2) over the screws on the wall.
5. Gently pull the base down on the screws until they lock into place.
6. Connect the Ethernet cable to the RJ45 jack on what in this position is the bottom of the device
(Fig. 1).
7. Connect the coaxial connector of the power adapter to the 5V DC jack on what in this position is
the bottom of the device (Fig. 1).