Operation Manual
Table Of Contents
- Table of Contents
- Copyright, Trademarks, Legal Disclaimers
- Important Information
- Introduction
- Setting Up
- Configuring
- Central Directory
- Firmware Update
- Web Interface Settings
37
v1.02
Admin and Installation Guide M700, M300 Firmware Update
6. Connect the repeater to a power outlet.
7. Press the reset tab on the back of the repeater for approx. 2 seconds until the LED blinks red
briefly and then switches to double green flashes.
Fig. 4
8. On the Repeater page, check the box to the left of the Idx and then click on Register Repeater(s).
Fig. 5
Upon successful registration, the Repeater page will show the repeater's and the base station's
RPNs, the repeater's IPEI, and the state as "Enabled".
Fig. 6
Manual registration
This method must be used for daisy-chaining two or three repeaters. The RPN for the repeater as
well as its DECT sync source must be selected manually from the respective drop-down menus.
1. Open the Repeaters page (Fig. 6, above).
2. Click on Add Repeater.
3. Enter a name for the repeater, for example a consecutive number or its location. If you do not
enter a name, the IPEI will be listed.
Reset tab