Operation Manual
Table Of Contents
- Table of Contents
- Copyright, Trademarks, Legal Disclaimers
- Important Information
- Introduction
- Setting Up
- Configuring
- Central Directory
- Firmware Update
- Web Interface Settings
38
v1.02
Admin and Installation Guide M700, M300 Firmware Update
Fig. 7
4. Select Manually from the DECT sync mode drop-down menu (Fig. 7).
5. Select the DECT sync source from the drop-down menu. In the example (Fig. 8, below), the DECT
sync source of the second repeater is the first repeater from Fig. 6, above, therefore RPN01 is
selected.
Fig. 8
6. Select the RPN from the drop-down menu of RPN.
Fig. 9
7. Click on Save.
8. Connect the repeater to a power outlet.
9. Press the reset tab on the back of the repeater (see Fig. 4, above) for approx. 2 seconds until the
LED blinks red briefly and then switches to double green flashes.
10. On the Repeater page, check the box to the left of the Idx and then click on Register Repeater(s).
Fig. 10