Operation Manual
Table Of Contents
- Table of Contents
- Copyright, Trademarks, Legal Disclaimers
- Important Information
- Introduction
- Setting Up
- Configuring
- Central Directory
- Firmware Update
- Web Interface Settings
40
v1.02
Admin and Installation Guide M700, M300 Firmware Update
Emergency alarm
Available as of FW v3.24 B0007. Seven emergency alarm profiles can be configured on this page. All
configured emergency alarm settings can be selected individually for any handset registered at the
base station if that handset has an emergency alarm function. After an emergency alarm profile has
been configured in this menu, it can be selected for individual handsets on the handset page.
Note: All features of the emergency alarm settings are available on the M85 only.
The M65 can be enabled to send an alarm call to the specified alarm number using the
factory settings. The M25 does not have an emergency alarm.
• Alarm type. Select Alarm Button from the drop-down menu to enable the alarm feature. Default
setting: Disabled.
• Alarm signal. The Call setting is mandatory. When the alarm button on the handset is pressed,
the handset will call the phone number specified in the handset's Alarm settings (see "Selecting
Emergency Alarm Setting on M700" on page 30 or "Selecting Emergency Alarm Setting on
M300" on page 34, respectively).
The following settings apply to the M85 only. The M65 uses the default settings regardless of the
setting, except for Howling which is available on the M85 only.
• Stop Alarm from Handset. This setting establishes whether or not an alarm can be cancelled
from the handset. Default setting: Enabled.
• Trigger Delay. Enter the number of seconds from the moment its alarm button is pressed that
the handset will wait before calling the alarm number or, if a pre-alarm delay has also been
configured, before the pre-alarm delay is triggered. Default setting: 0.
• Stop Pre-Alarm from Handset. This setting establishes whether or not a pre-alarm can be
cancelled from the handset. Default setting: Enabled.
• Pre-Alarm Delay. Enter the number of seconds from the moment its alarm button is pressed
that the handset will wait before calling the alarm number. The display will show the "Pre-alarm
triggered" message, and the emergency ringer, if set, will be played. Default setting: 0.
• Howling. This setting establishes whether or not the handset will emit a howl while it is dialing
the emergency number. Default setting: Enabled.