Operation Manual

49
v1.02
Admin and Installation Guide M700, M300 Firmware Update
Updating the base station
6. In the Update Base Stations section, click on one of the radio buttons. The default is Update this
Base Station Only.
7. Enter the three-digit firmware version for updating the base station in the text field of Required
Version, i.e., 323,324, etc.
8. Click on Start Update.
Updating registered handsets
You have provided the firmware to the handsets registered at the base station in steps 4 and 5, above.
The update of each handset will be performed the next time it is placed in the charger and will take
approximately one minute.
9. Place the handset in the charger to start the firmware update. The LED will flash rapidly, first
green, then red.
If the update was successful, the handset will turn on again, and the web interface will indicate
the completion of the update and the current firmware version on the handset.
Provisioning updates
Please see the separate Provisioning Guide M700/M300 in our Wiki.