Operation Manual

52
v1.02
Admin and Installation Guide M700, M300 Firmware Update
Setting Description
Handset State Present, detached, located, removed, enabled,.
Present@RPNxx: The handset is located at the base station with RPNxx (radio
fixed part number).
Detached: The handset is turned o.
Located: The handset is configured to locate on a specific base station, but is
unable to do so (e.g., the base station is turned o).
Removed: The handset has not been used for a specified amount of time.
Enabled: Registration has been set up for handset, but handset has not
registered yet.
Handset Type FW Info Type of handset (e.g., M65) and firmware version (e.g., 324.7) on the handset
FWU Progress During a firmware update, this field displays the update's progress.
O: No update in progress
Initializing: Update is starting
x%: Update in progress, x percent done
Verifying x%: Update writing completed, FW verification ongoing
Waiting for charger: Firmware has been transmitted to handset; update will
begin when handset is placed in charger.
Conn. term.wait: Firmware has been transmitted to repeater; update will
begin when system is idle.
Complete: Firmware on handset/repeater has been updated
Error: Unable to update (file not found, file invalid etc.)
VoIP Idx Index of configured SIP extensions, numbered consecutively by the base
station. With checkbox for selecting the extension for SIP registration and
deregistration.
Extension The extension number that is also shown on the handset's display
Display Name Optional. If entered, the name will be shown on the handset's display.
Server The server selected on the Add extension/Edit extension page.
Server Alias The server alias set on the Servers page.
State SIP registration state. If the field is empty, the handset is not SIP-registered.
Add/Edit Extension
These pages are used to configure new extensions and to edit existing ones, respectively. The two
pages contain the same settings. Handset selection, Extension setting, and Server selection are
mandatory. The remaining settings depend on the requirements of your PBX or VoIP provider and can
be left blank, if nothing is required.
• To open the Add extension page, click on Add extension (Fig. 2).
• To open the Edit extension page, click on the Extension number (Fig. 2).
Fig. 2