Operation Manual

14
v1.04
Provisioning Guide M700, M300 Settings and Configuration
Global Settings
Setting Value(s) Description
http_pass e.g. admin Defines the HTTP password for your base station.
Together with http_user it will protect your web
interface.
Default Value: admin
phone_name e.g. snom M700 Defines the name of the base station.
Default Value: snom M700
ntp_server e.g. 10.110.21.254 Specifies the domain name or the IP address of the
NTP server.
Default Value: <empty>
ntp_refresh_timer e.g. 3600 Specify the time in seconds after which the phone
contacts the NTP server again to refresh the time.
Default Value: 3600
vlan_id e.g. 101 This setting sets the VLAN id of the base in order to
connect to anything residing in a specific VLAN.
Default Value: <empty>
vlan_qos e.g. 7 This setting sets the VLAN priority of the base in
order to connect to anything residing in a specific
VLAN.
Default Value: <empty>
dns_server1 e.g. 8.8.8.8 This setting stores the address of the primary DNS
server. If DHCP is disabled, the address of the
primary DNS server has to be entered here.
Default Value: <empty>
dns_server2 e.g. 8.8.4.4 This setting stores the address of the secondary
DNS server. If DHCP is disabled, the address of the
secondary DNS server has to be entered here.
Default Value: <empty>
ip_adr e.g. 192.168.1.2 This setting changes the IP address of the device. If
DHCP is disabled, the IP address must be entered
here.
Default Value: <empty>
netmask e.g. 255.255.255.0 This setting changes the netmask of the device. If
DHCP is disabled, the subnet mask must be entered
here.Default Value: <empty>
gateway e.g. 10.0.0.1 This setting changes the gateway of the device. If
DHCP is disabled, the gateway must be entered here.
Default Value: <empty>
rtp_port_start e.g. 50004 This setting specifies the RTP start port which is
used for RTP trac.
Default Value: 50004
rtp_port_end e.g. 50044 This setting specifies the RTP end port which is used
for RTP trac.
Default Value: 50044
network_id_port e.g. 5060 This setting specifies the SIP port which is used for
SIP trac.
Default Value: 5060
dhcp o / on This setting specifies whether DHCP is enabled or
not. If it is disabled, the base will use the configured
static IP address.
Default Value: on