Operation Manual

17
v1.05
Provisioning Guide M700, M300 Settings and Configuration
Server Settings
Server Settings
Setting Value(s) Description
NOTE: Up to 10 servers with idx 1 to 10. Example: user_host idx="1"
srv_sip_use_one_tcp_
conn_per_ext
idx=1-10
o / on Specifies whether to use one
TCP connection per
SIP extension or not.
Default Value: o
srv_sip_signal_tcp_port
idx=1-10
o / on Specifies whether to signal TCP source port or not.
Default Value: on
srv_sip_server_alias
idx=1-10
e.g. snom sip server Specifies the name of the sip server.
Default Value: <empty>
srv_sip_show_ext_
name_in_hs
idx=1-10
o / on Specifies whether the e
xtension is shown on the
handset idle screen or not.
Default Value: on
srv_sip_enable_blind_
transfer
idx=1-10
o / on Specifies whether blind tr
ansfer is enabled or not
Default Value: on
network_vlan_
synchronization
o / on When the VLAN ID in a multicell system changes,
this setting determines whether the new VLAN ID
is sync'd to the other bases or not.
Default Value: on
srv_srtp_auth
idx=1-10
o / on Determines whether SRTP Authentication is used
or not. This setting has to be enabled when user_
srtp is set to on. Likewise this has to be turned o
when user_srtp is o.
Default Value: o
srv_sip_rtp_base_equal
idx=1-10
disabled / enabled Enables/disables R
TP from own base station.
Default Value: disabled
srv_sip_ua_data_
server_nat_adaption
idx=1-10
disabled / enabled Enables/disables NA
T adaption.
Default Value: enabled.
NOTE:
user_dtmf_info
idx=1-10
sip_inf
o_only = SIP info
o = RTP Events (RFC2833)
on = SIP info and RTP
Events (RFC2833 )
This setting changes depending on whether DTMF
events are signaled via SIP INFO messages or via
RTP events or both.
Default Value: o
srv_dtmf_payload_type
idx=1-10
0-127 Set up the payload type for out-of-band DTMF here.
Default Value: 101
srv_sip_transport
idx=1-10
udp / tcp / tls Specifies the transport protocol used for SIP
messages.
Default Value: udp
timer_support
idx=1-10
o / on Define whether sip-stack should support the use of
timer
s. Includes adding headers "Session-Expires"
and "Min-SE".
Default Value: on
Enabled: When the base station receives a SIP response to a REGISTER request with a “Via” header
that includes the “received” parameter (e.g.: Via: SIP/2.0/UDP 10.1.1.1:4540;received=68.44.20.1), it will
adapt its contact information to the IP address from the "received" parameter. The base station will
then send another REGISTER request with the updated contact information.
Disabled: The base station will ignore the "received" parameter.