Installation Guide

Self-Contained Ice Maker User Manual for Installation and Maintenance
1
  after proper installation, connect
the water source and turn on the power
supply, the machine will start working.
Please confirm that the machine is
operating normally when you turn it on for
the first time.
 


  with power on for the first time,
the ice maker will do self-check and pump
out remaining water.
  after the ice machine is
energized, the inlet valve opens and the
inlet water will flow in until it reaches the
set level; then the ice maker will do
defrosting one time.
   after pre-cooling for 30
seconds, the water pump starts, the water
flows through the evaporator smoothly and
evenly, the ice cubes are gradually formed
in the ice cube tray.
 : after the ice making process,
the water pump is turned off, the
defrosting valve is turned on, and after the
hot gas enters into the evaporator for
about 1-2 minutes, the ice cubes slides
from the evaporator into the storage bin.
 
     


  The ice maker will stop
working when you click the “on/off” button
on the panel during running process.
  in the running state, with the
storage bin filled to a certain height, the ice
sliding board cannot be rebounded or
reset because of the block of the freshly
produced ice cubes, the ice maker will
stop in 30 seconds.
  when the ice cubes
on the ice sliding board are taken away,
the ice maker will back to ice making
process in a few seconds.