Use and Care Manual

Glace Bay Ice Machine Installation, Maintenance and Operation Manual Page 6
• Installation site must be leveled. Adjustable feet at the bottom of the
machine are provided to level the unit.
• The installation site must be capable of supporting the weight of the ice
machine and a full bin of ice.
• The installation site may not be next to heat-generating equipment or in
direct sunlight.
• The installation site must be free of airborne and other contaminants that
could affect the ice machine’s life or ice quality. Installing your ice machine
near a source of yeast or similar material can result in the need for more
frequent sanitation cleanings due to the tendency of these material to
contaminate the machine.
2.3 Water Supply Requirements and installation
The water used for ice making must be in accordance with local drinking water
quality standards. External water filtration device may be installed on the supply
line as long as required water pressure is maintained.
The following water supply and plumbing requirements must be complied with or
the system may not operate correctly or damage may occur:
• Water Inlet Temperature must be between 0.6°C [33°F] and 32°C [89.6°F].
WARNING: The ice machine must not be connected to hot water supply. Please
review and comply with water temperature requirements above.
• Ice Making Water Pressure must be between 0.13 Mpa [19 psi] and 0.55
Mpa [80 psi]. If water pressure exceeds the maximum recommended
pressure, a water pressure regulator will be required.
• Cooling Water Pressure must be between 0.59 Mpa [85.6 psi] and 1.17
Mpa [169.7 psi].
Sides
15.0 cm [5.90 in]
Back
20.0 cm [7.87 in]
Front
30.0 cm [11.81 in]