Operation Manual

TROUBLESHOOTING
Please read this user manual carefully before using the DAB2000 vehicle DAB
adaptor. If you still have difficulties in using this unit, this section gives some of
the most likely solutions to the problems you might have.
 I cannot find any DAB stations.
Ensure that DAB coverage exists in your area. Please visit www.worlddab.org
or www.digitalradionow.com to check DAB coverage for your area.
 I can find DAB stations, but I cannot get any sound.
Make sure that the vehicle radio is not muted; check the volume settings of
the vehicle radio.
 I have forgotten the FM transmission frequency setting of DAB2000.
Press the FM button and the screen will show the current FM Transmitting
frequency.
 I cannot hear any DAB program when I start my vehicle and turn on
the vehicle radio.
Check the following:
1. Follow the instruction in the section STARTING UP THE SYSTEM to
initialize the FM transmitting frequency on DAB2000 and the vehicle
radio.
2. Make sure DAB2000 is not in the auxiliary mode, please refer to section
To set the auxiliary input mode to check and return to DAB mode.
 While listening to a DAB station, I have lost reception and only hear
static noise or another FM program
1. Check if the DAB2000 station information shows 《 POOR SIG 》 or
《 UNAVAIL 》, if so, you may be leaving the signal coverage area, please
refer to the section To listen to the DAB stations and to select another
station. In addition, the stati on may be temporarily unavailable as you
drive into a tunnel, for example.
2. If DAB2000 is in AFC mode, the FM transmitting frequency for DAB2000
and the vehicle radio listening frequency may be out of sync. To reset
them, do the following: