Operation Manual

RS232
RD
10
Installing your Snooper Evolution using the Windscreen Suction
Cup bracket
You can mount your Evolution to the inside of your vehicles windscreen using
the suction cup windscreen bracket provided. Simply select a position within
the windscreen so that the top of the unit has a clear view of the sky,
remembering that you need to connect the power connection cable as well as
ensuring that you can read the LED text display and reach the controls
safely.
Follow these instructions to mount the unit in this way.
•
Install the suction cups onto the bracket by fitting them into the holes as per
the diagram below.
•
Clean the area where you wish to position the bracket thoroughly with a
good quality glass cleaner
•
Adjust the bracket to the rake of the windscreen by carefully bending it so
that when the Evolution is mounted onto the windscreen it is perpendicular
to the road ahead. The display must be facing the driver and the controls
should be within reach of the driver.
The Evolution is supplied with two power cables one of which can be
connected to the vehicles cigarette lighter socket as follows.
•
Connect the smaller right angled plug to the socket marked ‘DC 12V’ on the
Evolution.
•
Push the cigarette lighter plug firmly into the vehicles cigarette lighter
socket. (For the hardwire instructions please refer to the relevant section.)
•
Slide the Evolution onto the bracket until it is secure.
•
To remove the Evolution simply slide the unit off the bracket from the front.
•
The Snooper Evolution is now ready for use.
Installing the Evolution
Installing the Evolution
Return to contents