User manual

71 • EN
Return to contents
5.14 FM Transmitter (FM-T)
FM Transmitter On: All of the audio output from the 6 series will be transmitted
via FM frequency to the vehicle radio
1. Press FMT On
2. Scan the FM frequencies on you vehicle radio and locate empty frequencies
which, preferably, does not have any music or talking, make a note of the
frequency E,G 108.00Mhz or 87.5MHz are normally clear in the UK.
3. Press ‘+’ or ‘-’ FMT tune the 6 series to the same frequency. EG 108.00MHz
4. Press OK to save.
5.15 Route Timer
This function allows you to set an alert for when you need to take a break. Set the maximum driving time allowed and set the
advanced warning time you require before your next break is due. The Route timer clock will then keep you advised of the driving
time you have left and will automatically alert you when it’s time to take a break.
To access this function:
 Press the centre of the screen to enter the ‘Navigate to’ menu.
 Press the ‘Configure’ button.
 Press the arrow once.
 Press the ‘Route Timer’ icon.
The following screen will be displayed. In this screen you can:
 Activate the route timer function so that it is shown in the map display. Note:
If ‘ Yes’ is not selected then you cannot amend the ‘Set time limit’ and ‘Alert
time’ options
 Set the duration of the time limit in hours and minutes - use the arrows to increase or decrease the time. The default setting is four
hours.
 Before the time limit is up you can configure the unit to provide you with an alert to remind you that you are nearing your break
period. The default period is 20 minutes.
Once you have set your desired preferences press ‘OK’ to confirm the settings.
If you wish to keep the setting unchanged, you can exit the menu by pressing the return arrow
located in the bottom right
hand corner of the display.
Route timer
Pause Stop Reset
Press route timer to
show options
6 series V110.14 EN