Installation Instructions

RC100 Reversing Camera Wiring Instructions

Supplied in the box should be the following parts.

1 x Rc100 Reversing Camera

1 x 5 Metre S-Video Camera Cable

1 x RC100 Camera Bracket

1 x S7000 Connection Cable ( use only if connecting to a Snooper S7000)

1 x RC100 Power And Video Camera Connection Cable

As Pictured below this is the connection cable for the reversing camera to the extension lead, power

and video output.

To connect this cable to a vehicle please follow the instructions below.

PAGE 1
RC100 Reversing Camera Wiring Instructions Supplied in the box should be the following parts. 1 x Rc100 Reversing Camera 1 x 5 Metre S-Video Camera Cable 1 x RC100 Camera Bracket 1 x S7000 Connection Cable ( use only if connecting to a Snooper S7000) 1 x RC100 Power And Video Camera Connection Cable As Pictured below this is the connection cable for the reversing camera to the extension lead, power and video output. To connect this cable to a vehicle please follow the instructions below.
PAGE 2
1. Connect the red wire to a triggered live connection e.g. reversing light or reversing switch. 2. Connect the Green wire to a permanent live connection e.g. in the fuse box or another source. 3. Connect the black wire to an earth point or a negative wire on the vehicle. 4. Connect the Yellow video cable to the input of the device to accept the connection. Once you have done this then connect the camera directly to the lead to confirm the connection is correct and functions properly.