Operation Manual
11 • EN
Return to contents
Installing
Snooper comes with a windscreen bracket so that the unit can be mounted onto your vehicles windscreen.
When installing Snooper please ensure that:
The unit, with its built in GPS antenna has a clear view of the sky.*
It is located in a position where you can easily view the LCD display without having to take your eyes too far from the road ahead
and that you can reach the controls safely.
Does not interfere with the vehicles controls.
Does not jeopardise the drivers or passengers safety.
You will be able to remove the device to perform downloads.
PLEASE NOTE: Be careful to choose a location that does not block the drivers view or where it might endanger the driver or
passengers should your vehicle suddenly come to a stop or be involved in an accident.
Installing Snooper using the Windscreen Suction Cup bracket
You can mount Snooper to the inside of your vehicles windscreen using the windscreen bracket provided.
Clean the area where you wish to position the bracket thoroughly
with a good quality glass cleaner. This allows a more secure seal
on the windscreen.
Place the suction cup and bracket on the windscreen and push
the locking lever towards the windscreen to secure the bracket.
Adjust the angle of the bracket so that when the unit is attached
to it you can view the display and operate the controls safely.
Position Snooper onto the bracket, by inserting the bottom of the
unit first and finally clipping the top of the bracket into the slot
on the top of the unit. To remove Snooper, simply unclip the unit
by pushing the top of the bracket and taking the unit from the
holder.
Snooper can be powered directly either from the internal battery
if it is fully charged or powered from the cigarette lighter socket. To use the cigarette lighter socket, plug the USB connector on
one end of the power cable into the USB socket on the side of Snooper and plug the larger plug into the cigarette lighter socket of
your vehicle.
Please Note: Only use the cigarette lighter power cable provided with Snooper. Snooper operates on 5V and using any other
cigarette lighter power cable will damage your device and void the warranty.
Locking
lever